Storage - RIDGID WD10600 Owner's Manual

STORAGE

When vacuuming is complete, your RIDGID Wet/Dry
Vac has convenient storage locations.
ACCESSORY STORAGE (Fig. 11)
1. For Storage: Slide the Extension Wands (G) and the
Accessories (H, I & L) onto the Accessory Caddy
Posts.
2. To Remove Wands and Accessories: Lightly rotate
and pull upward.
CORD STORAGE (Fig. 12)
1. To Store Cord: Wrap the Power Cord around the
Powerhead Carry Handle/Power Cord Wrap (C)
beneath the Two Tabs.
2. Secure the Power Cord using the Cord Clip on the
Polarized Plug.
HOSE STORAGE (Fig. 12)
1. The Tug-A-Long Positive Locking Hose with
Dual-Flex (E) may be stored by wrapping it around
the Powerhead Assembly (A) and plugging the open
Hose end into the Vac Inlet Port, as shown.
LOCKING ACCESSORIES (Fig. 13)
Your RIDGID Wet/Dry Vac includes Locking Accessories
to prevent the Accessories from falling off when in use.
1. To Connect the Locking Accessories: Align the
Nozzle Ridges of the Accessory with the Locking
Tab of your Extension Wand (G). Press to secure
the Nozzle to the Extension Wand.
2. To Disconnect the Locking Accessories: Twist
the Nozzle and Extension Wand to disengage the
Nozzle Ridges and pull. You may also press the
Locking Tab and pull to disengage.
WARNING:
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings
blocked; keep free of dust, lint, hair or anything
that may reduce air flow.
CAUTION:
Do not operate vacuum while the hose is still
wrapped around the powerhead assembly in the
storage position.
(G)
(H)
(C)
Power
Cord
(A)
(E)
(B)
(G)
Locking
Tab
9
Fig. 11
(I)
(G)
(L)
R
Accessory Caddy
Storage (4)
Fig. 12
Tab (2)
Power Cord
Clip
Vac Inlet
Port
Fig. 13
Nozzle Ridges
Accessory