Makita PF400MP Original Instruction page 6

2. Insert the pipe into the pump head so that the hole
on the pipe is aligned with the hole on the pump head.
Tighten 2 bolts securely to fix the pipe.
Fig.4
► 1. Hole 2. Pipe 3. Bolt
NOTE: When tightening the bolts, apply 2.5 - 4.5 N•m
as tightening torque.
Mounting the attachment pipe
CAUTION:
Always check that the attachment
pipe is secured after installation. Improper instal-
lation may cause the attachment falling off from the
power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1.
Remove the cap from the end of the pipe.
1
Fig.5
► 1. Pipe 2. Cap
NOTICE:
Do not dispose of the cap since the cap
is necessary for storing the attachment.
2. Turn the lever toward the attachment.
1
Fig.6
► 1. Lever
3. Align the pin with the arrow mark on the power
unit. Insert the pipe until the release button pops up.
2
Make sure that the position line is on the tip of the arrow
mark on the power unit, and the arrow mark on the
power unit and the arrow mark on the pipe are facing
each other.
3
Fig.7
► 1. Release button 2. Arrow mark on the power unit
3. Pin 4. Position line 5. Arrow mark on the pipe
4.
Turn the lever toward the power unit.
2
Fig.8
► 1. Lever
Make sure that the surface of the lever is parallel to the
pipe.
NOTICE:
attachment pipe inserted. Otherwise the lever may
tighten the entrance of the drive shaft too much and
damage it.
6 ENGLISH
1
2
1
Do not tighten the lever without the
1
3
4
5