How To Configure An Infrastructure Mode Profile - NETGEAR WG511T User Manual

User Manual for the NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T

How to Configure an Infrastructure Mode Profile

Follow the instructions below to configure an infrastructure mode profile for connecting to an
access point.
1. Run the WG511T Configuration Utility.
Make sure the WG511T software is installed and the WG511T is fully inserted in an
a.
available CardBus slot in your PC.
Open the configuration utility by clicking on the WG511T icon
b.
system tray.
Figure 4-2: Smart Wireless Settings page
Click on the Settings tab to display the view shown above.
c.
2. Configure the wireless Network settings.
In the Network Type section, be sure that Infrastructure is selected.
a.
Configuration
in the Windows
4-3