Configuring Universal Plug And Play - NETGEAR RangeMax DGN3500 User Manual

c. Select Private if you want to limit access to the LAN only. The static route will not be
reported in RIP.
d. Select Active to make this route effective.
e. Enter the destination IP address of the final destination.
f. Enter the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255.
g. Enter the gateway IP address, which must be a router on the same LAN segment as the
router.
h. Enter a number between 2 and 15 as the metric value in the Metric field. This represents
the number of routers between your network and the destination. Usually, a setting of 2 or
3 works.
4. Click Apply. The Static Routes table is updated to show the new entry.
Figure 5-7

Configuring Universal Plug and Play

Universal Plug and Play (UPnP) helps devices, such as Internet appliances and computers, access
the network and connect to other devices as needed. UPnP devices can automatically discover the
services from other registered UPnP devices on the network.
Advanced Configuration
RangeMax Wireless-N DSL Gigabit Modem Router DGN3500 User Manual
v1.0, November 2009
5-15