Configuring ADSL Settings
Note: For information about how to install ADSL filters, see the Setup Manual.
NETGEAR recommends that you use the Setup Wizard to automatically detect and configure your
ADSL settings. This usually works fine. However, if you have technical experience and are sure of
the multiplexing method and virtual circuit number for the virtual path identifier (VPI) and virtual
channel identifier (VCI), you can specify those settings here.
Note: NETGEAR recomments using the Setup Wizard to select the correct country to
optimize detection of the ADSL settings.
If your ISP provided you with a multiplexing method or VPI/VCI number, then enter the setting:
1. From the main menu, select ADSL Settings.The ADSL Settings screen displays.
Figure 1-6
2. In the Multiplexing Method drop-down list, select LLC-based or VC-based.
3. For the VPI, type a number between 0 and 255. The default is 8.
4. For the VCI, type a number between 32 and 65535. The default is 35.
5. Click Apply.
Connecting Your Router to the Internet
RangeMax Wireless-N DSL Gigabit Modem Router DGN3500 User Manual
v1.0, November 2009
1-8