Operation - Makita TW0200 Instruction Manual

Installing or removing socket
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the
socket.
► Fig.3: 1. Socket 2. Anvil
For socket without O-ring and pin
To install the socket, push it onto the anvil of the tool
until it locks into place.
To remove the socket, simply pull it off.
For socket with O-ring and pin
Move the O-ring out of the groove in the socket and
remove the pin from the socket. Fit the socket onto the
anvil of the tool so that the hole in the socket is aligned
with the hole in the anvil. Insert the pin through the hole
in the socket and anvil. Then return the O-ring to the
original position in the socket groove to retain the pin.
To remove the socket, follow the installation procedures
in reverse.
► Fig.4: 1. Socket 2. O-ring 3. Pin
Hook
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
Installing and removing hook
► Fig.5: 1. Hook
Expand the upper part of the hook in both directions
and remove it. To install the hook, follow the removal
procedure in reverse.

OPERATION

CAUTION:
• Always hold the tool only by the handle when
performing an operation. Do not touch the metal
part.
► Fig.6
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Standard bolt
200
180
160
140
120
100
80
60
40
20
0
Fastening time (S)
High tensile bolt
200
180
160
140
120
100
80
60
40
20
0
1
Fastening time (S)
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
5 ENGLISH
M16X80
M16
M12X80
M10X80
M12
M10
3
1 2
M12X80
M10X80
M12
M10
2 3 4
4
5