Conductivity Monitor - GE AKTA pilot 600 User Manual

3.9

Conductivity monitor

Introduction
This section describes the conductivity monitor modules:
•
•
The purpose of these monitors is to continuously measure the conductivity of samples
and buffers in the flow path.
Illustration
The illustration below shows the front of the conductivity monitor modules. The two
modules are physically identical.
Part
1 to 4
Function
The conductivity monitors can be used together with watch functions in UNICORN to
control different steps in a chromatography or preparation run.
The individual cell constant for each monitor is calibrated on delivery but can be re-cal-
ibrated if needed, see
ÄKTA pilot 600 User Manual 29274559 AA
Pre-column conductivity monitor (optional)
Conductivity monitor (always installed in the system)
1
3
Description
Inlet/outlet
Section 5.4.2 Calibrate the conductivity monitor, on page
3 Description of modules

3.9 Conductivity monitor

2
4
104.
51