Gp Gpio Error Pause; Gr Gain Reflective Value; Gs Gpio Slew; Hc Head Cleaning - Honeywell E-Class Series User Manual

GP GPIO Error Pause

This command enables or disables the printer from sending a service required fault to
the GPIO output (Applicator Interface CCA, Type 2 only).
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:

GR Gain Reflective Value

This command sets the sensitivity of the reflective media sensor.
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:

GS GPIO Slew

This command sets the GPIO slew function and control.
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:
Value
0
1
2
3
4
* Pulse must be at least 60 milliseconds in length; functions as if pressing the Feed
Key, clearing alarms and advancing media.

HC Head Cleaning

This command controls the print head cleaning routine. The entered value specifies
the inch (or centimeter) count to reach before prompting a print head cleaning. If the
DPL Command Reference
GP
E, D
E = Enabled, D = Disabled
N/A
GR
0 - 31
N/A
N/A
GS
0 - 4
See table below.
N/A
Slew Interpretation
Standard (Active Low)
Low Pulse *
High Pulse *
Slews while low (Active Low)
Slews while high (Active High)
91