Ba Backup After Print; Bd Backup Delay; Bl Backup Label; Bp British Pound - Honeywell E-Class Series User Manual

BA Backup After Print

This command determines the timing of the label back up positioning when the
present distance is set and the GPIO option or Present Sensor option (including Peel
and Present) is enabled.
When enabled, the printer immediately backs up the label after the applicator-issued
start of print signal is received or the label is removed, resulting in faster throughput.
If disabled, the printer will not initiate repositioning until the next label is ready to
print (may help prevent the curling of the label edge).
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:

BD Backup Delay

This command sets a time delay for the retraction of a presented label in one-fiftieth
(1/50) of a second increments.
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:

BL Backup Label

This command determines the timing of reverse label motion when the GPIO option is
installed and enabled. See
more information.
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:

BP British Pound

This command, when enabled, will automatically switch from the Number symbol (#)
found at 0x23 (default PC-850 Multilingual Symbol Set) to the British Pound symbol
(£) at 0x9C.
DPL Command Reference
BA
Y, N
Y = Enabled, N = Disabled
N/A
BD
0 - 255
1/50 second
N/A
General Purpose Input Output (GPIO) Port Applications
BL
0, 3, 4
0 = Disabled, 3 = Active Low, 4 = Active High
N/A
for
75