Accident Report; Electrical System; Clamping Devices For Workpieces And Tools - Grizzly G0877 Owner's Manual

1.14.1 Using lifting equipment
WARNING!
The use of unstable lifting and load suspension gear that might break under load can
cause severe injuries or even death. Observe the accident prevention regulations issued
by your Employers Liability Insurance Association or other competent supervisory
authority, responsible for your company.
Check that the lifting equipment and load-suspension gears are of su cient load
capacity and are in perfect condition.
Fasten the loads properly.
Never walk under suspended loads!
1.14.2 Mechanical maintenance work
Remove or install protection safety devices before starting any maintenance work and re-install
them once the work has been completed.This includes:
Covers,
m
Safety indications and warning signs,
m
Earth (ground) connections.
m
If you remove protective or safety devices, re- t them immediately after the completing the
work. Check if they are working properly!
1.15

Accident report

Inform your superiors and Grizzly Industrial, Inc. immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are noti ed, the faster the causes can be eliminated.
INFORMATION
We point out the speci c dangers when performing works with and on the CNC-machine when
describing such works.
1.16

Electrical system

Have the machine and/or the electrical equipment checked regularly, at least every six months.
Immediately eliminate all defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. Immediately disconnect the CNC-machine if there are any anoma-
lies in the power supply!
1.17

Clamping devices for workpieces and tools

ATTENTION!
Attention when taking over the existing clamping devices. Pleased check critically if the
clamping device is appropriate for your CNC-machine .
Only use clamping devices which have a complete inherent sti ness.
m
Contact the manufacturer of the clamping device regarding the reuse of the clamping
m
devices after damages on the clamping devices due to collisions.
Correctly insert the workpiece and make sure that the machine is proper working
m
condition.
-20-
"Maintenance" on page 76
Model G0877 (Mfd. Since 02/19)