Fig. 10
[2]
Fig. 11
[5]
[1]
[2]
[6]
[4]
[8]
[9]
Fig. 12
[2]
[1]
Fig. 13
[2]
[3]
[1]
7
[3]
[1]
8
F/R change lever [2]
[3]
Lens, LED circuit [3]
LED circuit [4]
[7]
Stator [5]
Sensor circuit [6]
USB circuit [7]
Switch [8]
Buzzer circuit [9]
Controller [10]
[10]
Terminal [11]
9
[11]
10
[3]
Be careful not to strip the head of Tapping screw PT
2x6 [2].
11
[4]
Be careful not to strip the head of Flat head screws
Remove Terminal unit [3] straight while being
6 / 35
Remove Gear assembly [2] and Rotor [3] from
Housing R [1].
Remove the following parts from Housing R [1]:
Disconnect Connectors and Receptacles.
Remove Tapping screws PT 2x6 [2] (3 pcs) from
Stator [1] with a No.1 Phillips screwdriver, then
remove Circuit board [3].
Note
Remove Flat head screws M3x6 [2] (3 pcs) from
Stator [1] with a No.1 Phillips screwdriver, then
remove Terminal unit [3].
Note
M3x6 [2] (3 pcs).
careful not to deform Thermistor connection
terminals [4].