Removing And Installing Components - Cisco 5000 Series Hardware Installation Manual

Removing and Installing Components

After the switch boots, verify that the LED operation is as follows:
Step 6
•
•
•
•
Note
Try removing and reinstalling a component that is not operating correctly. If it still does not operate
Step 7
correctly, contact your customer service representative for a replacement.
Note
Verify that the system software has booted and the switch has initialized without error messages.
Step 8
If any problems occur, see
an issue, contact your customer service representative.
Complete the worksheets provided in
Step 9
reference.
A setup utility automatically launches the first time you access the switch and guides you through the
Note
basic configuration. For instructions on how to configure the switch and check module connectivity, see
the Cisco Nexus 5000 Series CLI Configuration Guide or the Cisco Nexus 5000 Series Fabric Manager
Configuration Guide.
Removing and Installing Components
This section describes how to remove and install components for the Cisco Nexus 5548P switch or the Cisco
Nexus 5000 Series switch.
This section includes the following topics:
•
•
•
•
Cisco Nexus 5000 Series Hardware Installation Guide
3-22
S e n d c o m m e n t s t o n 5 k d o c s @ c i s c o . c o m
Fan module—Status LED is green.
Power supply—Status LED is green.
After initialization, the system status LED is green, indicating that all chassis environmental
monitors are reporting that the system is operational. If this LED is orange or red, then one or more
environmental monitor is reporting a problem.
The Link LEDs for the Ethernet connector should not be on unless the cable is connected.
The link LEDs for the Fibre Channel ports remain yellow until the ports are enabled, and the
LED for the Ethernet connector port remains off until the port is connected.
If you purchased this product through a Cisco reseller, contact the reseller directly for technical
support. If you purchased this product directly from Cisco, contact Cisco Technical Support at
this URL: http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml.
Appendix E, "Troubleshooting Hardware
Removing and Installing Expansion Modules, page 3-23
Removing and Installing Power Supplies, page 3-26
Removing and Installing the Fan Module, page 3-28
Removing the Cisco Nexus 5548P switch or the Cisco Nexus 5000 Series Switch, page 3-31
Chapter 3 Installing the Cisco Nexus 5500 Platform or 5000 Series Switch
Appendix D, "Site Planning and Maintenance Records"
Components". If you cannot resolve
for future
OL-15902-01