Appendix; E Overview; Troubleshooting Hardware Components; Snmp Traps - Cisco 5000 Series Hardware Installation Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m

Troubleshooting Hardware Components

This appendix describes how to identify and resolve problems that might occur with the hardware
components of the Cisco Nexus 5500 Platform switch or the Cisco Nexus 5000 Series switch.
It includes the following sections:
•
•
•
Overview
The key to success when troubleshooting the system hardware is to isolate the problem to a specific
system component. The first step is to compare what the system is doing to what it should be doing.
Because a startup problem can usually be attributed to a single component, it is more efficient to isolate
the problem to a subsystem rather than troubleshoot each separate component in the system.
Problems with the initial power up are often caused by a module that is not firmly connected to the
backplane or a power supply that has been disconnected from the power cord connector.
Overheating can also cause problems with the system, though typically only after the system has been
operating for an extended period of time. The most common cause of overheating is the failure of a fan
module.

SNMP Traps

You can set SNMP traps to monitor fans, power supplies, and temperature settings, or to test a call home
application. Use the following commands to set SNMP traps:
•
•
•
OL-15902-01
Overview, page E-1
SNMP Traps, page E-1
Switch Hardware Best Practices, page E-2
test pfmtest-SNMP-trap fan
test pfmtest-SNMP-trap power supply
test pfmtest-SNMP-trap temp-sensor
A P P E N D I X
Cisco Nexus 5000 Series Hardware Installation Guide
E
E-1