AEG PSUM1000 Original Instruction page 9

NoTE: ALWAYS move mounted saw opposite the wheeled end of
stand (in the open position) prior to transporting or taking down
unit and ensure saw mounting brackets are securely locked.
NoTE: If a sliding compound mitre saw is mounted on the stand,
it may be necessary to slide the power head/blade assembly
forward and lock in place when going through doorways or other
narrow openings.
■ Remove any workpieces, clamps, or other accessories from the
tool.
■ Retract support arm. Refer to Using the Support Arms later in
this manual.
■ Stand at the wheel end of the stand and grasp the handle.
■ Step on the release lever. Lift the handle up and away from the
body until the unit rests on the wheels and frame support and
release lever clicks into place. This is the vertical closed position.
NoTE: You may have to step onto the axle frame between the
wheels to securely lock the release lever into place.
To avoid serious personal injury when raising the front of the
stand, bend your knees so you can lift with your legs, not your back.
Use the handle to raise the stand. Do not raise by any part of the
mitre saw that is attached to the stand. Failure to heed this warning
may result in possible injury and damage the product.
To lower the stand in closed position:
■ Stand at the wheel side of the stand and grasp the handle.
■ Tilt the unit toward you and then slowly lower it to the ground.
This is the horizontal closed position.
Fig. 12
1
1 - Push the release lever
wArNING
wArNING
Be careful not to pinch fingers when lowering to the ground.
VERTICAL CLOSED POSITION
Fig. 13
Fig. 14
HORIZONTAL CLOSED POSITION
9
CAUTIoN
9