AEG PSUM1000 Original Instruction page 12

Fig. 19
1
2
3
4
5
1 - Hex nut (M8) 4 - Bolt (M8 x 30mm or M8 x 50mm)
2 - Lock washer (M8) 5 - Saw mounting bracket
3 - Flat washer (M8) 6 - Stable support
Fig. 20
1
2
3
4
1 - Hex nut (M8)
2 - Lock washer (M8)
3 - Flat washer (M8)
4 - Bolt (M8 x 30mm or M8 x 50mm)
■ Place the saw mounting bracket underneath the raised side of
the saw, and insert bolt through bracket slots and mounting holes
in saw.
NoTE: The saw mounting brackets should be placed so that the
lock levers face the front of the saw.
■ Loosely secure in place using a flat washer, lock washer, and hex
nut.
■ Insert second bolt through bracket and saw, then loosely secure.
NoTE: Dummy fitting on top rail will assist in getting a better
alignment.
12
6
6
5
7
5 - Saw mounting bracket
6 - Mounting surface
(not included)
7 - Lock lever
■ Repeat procedure to attach second bracket to saw.
■ After making sure both brackets are parallel to each other, lightly
tighten all four nuts to hold in position.
If the saw has holes that do not line up with the slots in the saw
mounting brackets: (see figure 20)
■ Disconnect the saw from power supply and lock saw arm in the
down position.
■ Mount the saw to a mounting surface at least 15 mm thick using
bolts, washers, and nuts (not included).
■ Drill holes in the mounting surface to match the position of the
slots in the saw mounting brackets.
■ Place the saw mounting bracket underneath the mounting
surface, and insert bolt through bracket slots and the mounting
surface.
NoTE: The saw mounting brackets should be placed so that the
lock levers face the front of the saw.
■ Loosely secure in place using a flat washer, lock washer, and hex
nut.
■ Insert second bolt through bracket and the mounting surface,
then loosely secure.
NoTE: Dummy fitting on top rail will assist with getting a better
alignment.
■ Repeat procedure to attach second bracket to the mounting
surface.
■ After making sure both brackets are parallel to each other, lightly
tighten all four nuts to hold in position.
MoUNTING THE MITrE SAw To THE STAND
See figures 21 - 22.
Do not mount mitre saw to the stand before ensuring the stand
can be opened and locked securely. Failure to do so may result in
possible injury and damage the tool.
■ Make sure the mounting bracket lock levers are in the unlocked
position.
■ Lift the saw and bracket assembly, allowing the assembly to tilt
slightly toward your body.
Fig. 21
1
1 - Unlocked position
2 - Locked position
12
Fig. 22
wArNING
2