Rear View - AEG PSUM1000 Original Instruction

1 - Unlocked position
2 - Locked position
Fig. 22
1 - Locking lever release trigger
2 - Push down to lock
3 - Locking lever
■ While still tilted toward you, place the front end of the saw and
bracket assembly onto the top rails so the front clamps of the
bracket assembly seat fully over top rails.
To avoid serious personal injury, make sure the curved front edge
of the saw mounting brackets are securely seated onto the top rails
before seating the other end of the brackets. Failure to do so could
cause you to lose control of the saw and bracket assembly, which
could cause serious personal injury.
■ Lower the saw and bracket assembly to allow the rear clamp of
the bracket to seat fully over the toprails.
■ Lock the brackets in position by lowering the locking levers.
NoTE: Continue to hold the saw and bracket assembly with one
hand until both levers are securely locked.
■ Check position and adjust, if necessary, to make sure the weight
of the saw is evenly balanced over the top rails.
■ Ensure the saw is fully seated and locked in position, then
securely tighten the four nuts holding the saw to the saw
mounting brackets.
The saw mounting brackets are designed to fit snugly over the top
rails with locking levers in the open position. With the locking levers
in the lowered (locked) position, you should not be able to slide the
saw mounting bracket assembly along the top rails or remove the
bracket assembly from the top rails. If the saw mounting brackets
will not fit over the top rails, or if the brackets can be removed from
the top rails when the levers are locked, remove bracket assembly
immediately and adjust bracket adjustment screw. See the
Maintenance section of this manual. Failure to heed this warning
may result in serious personal injury.
2
3
1
wArNING
wArNING
To remove saw from the stand:
■ Squeeze locking lever release trigger and raise the locking levers
to unlock the saw mounting brackets assembly.
■ Grasp the brackets on both sides of the assembly and lift away
from the top rails to disengage.
■ With the assembly tilted slightly toward you, lift the front part of
the assembly to disengage from the front edge of the top rails.
TrANSPorTING THE STAND
■ Retract the supporting arms, then place and lock the stand in the
vertical closed position. (Figure 13)
NoTE: ALWAYS move mounted saw opposite the wheeled end of
stand (in the open position) prior to transporting or taking down
unit and ensure saw mounting brackets are securely locked.
■ Stand at the wheel side of the stand and grasp the handle.
■ Tilt the stand toward you until it balances on the wheels, then roll
the stand to the desired location.
STorING THE STAND
■ The stand should be stored on a stable flat surface in the vertical
or horizontal closed position.
If the stand will not remain upright, store in the horizontal closed
position. Failure to do so may result in stand falling, resulting in
injury or damage to stand and/or saw.
MoUNTING AN oPTIoNAL work SUrFACE
See figure 23.
By mounting a 19 x 190 x 882 mm piece of wood, PVC, or similar
lightweight material, an additional work surface can be created. Mount
the surface as shown using six 19 mm screws (not included).
Fig. 23
13
CAUTIoN

REAR VIEW

(not included)
13