Step 3: Attaching The Handle - AEG PSUM1000 Original Instruction

STEP 3: ATTACHING THE HANDLE

See figure 5.
Be careful to avoid pinching your fingers or hands when installing
the handle onto the frame.
Attach the handle on the end of the stand assembly opposite the
wheels.
■ Insert handle into stand assembly as shown.
■ Align the holes in the handle with the holes in the stand assembly.
■ Insert the bolt through the holes in the handle and the stand
assembly.
■ Place acorn nut onto bolt and tighten.
■ Repeat on other side.
Fig. 5
2
3
1
Fig. 6
1 - Frame support
2 - Foot bolt (M8 x 55mm)
3 - Feet
4 - Wing nut (M8)
4
3
CAUTIoN
2
1 - Handle
2 - Handle bolt (M8 x 45mm)
3 - Acorn nuts
1
4
3
2
2
STEP 4: INSTALLING THE FrAME SUPPorT
See figure 6.
Install the frame support on the stand assembly on the same end as
the wheels.
■ Insert frame support into stand assembly as shown.
■ Align the holes in the frame support with the holes in the stand
assembly.
■ Place feet onto the stand assembly with logo facing the frame.
Align the holes in the feet with the holes in the frame and frame
support.
■ Insert foot bolts (M8 x 55mm) through the holes in the feet so the
bolts extend up through the frame and frame support.
■ Install wing nuts and tighten.
■ Repeat on other side.
STEP 5: SECUrING THE ToP rAILS To THE CENTrAL brACE
See figure 7.
■ Raise the stand assembly so that it rests on its wheels and frame
support. This is the vertical closed position.
NoTE: Do not place the stand assembly in the vertical closed
position until the frame support is installed and all previous
assembly procedures have been followed.
■ Align the holes in the brackets with the holes in the central brace
as shown.
■ Insert bolts through the holes in the bracket and central brace.
■ Place nuts onto bolts and tighten securely, do not over tighten.
To reduce the risk of injury, make sure top rails are secured to the
central brace. Failure to secure the top rails could cause instability
during use resulting in possible serious injury.
Fig. 7
1
2
1 - Top rails
2 - Frame bolt (M8 x 55mm)
3 - Central brace
7
wArNING
3
2
4
5
4 - Lock nut (M10)
5 - Bracket
7