AEG PSUM1000 Original Instruction page 8

STEP 6: oPENING THE MITrE SAw STAND
See figure 8-9.
■ Stand at the wheel side of the stand assembly and grasp the
handle.
■ Step on the release lever and pull the handle toward you at the
same time.
■ Ease the stand assembly toward the floor by pushing the handle
toward the floor until the stand is in an open position.
NoTE: The release lever will close over the central brace locking
the stand in an open position.
STEP 7: ATTACHING work SToPS To work SUPPorTS
See figures 10.
■ Align slot in work stop with hole in work support, as shown.
■ Slide bolt through both the work support and work stop.
■ Install adjustment knob and tighten securely.
■ Repeat with other work stop.
Fig. 8
1
1 - Push the release lever
Fig. 9
2
4
8
1
3
1 - Top rails 3 - Feet
2 - Central brace 4 - Wheel
STEP 8: INSTALLING THE work SUPPorTS
See figures 11.
The work supports brace the workpiece during cutting operations.
■ Slide the support arm out for accessibility. Refer to Using the
Support Arms later in this manual.
■ Insert the work support into bracket.
NoTE: Work supports should be positioned to provide support in
front of saw fence.
■ Insert adjustment knob through knob hole on side of bracket and
tighten to secure into position.
■ Repeat on the other end.
STEP 9: CLoSING THE STAND
See figures 12 - 14.
■ If a mitre saw is assembled on the stand, make sure to place the
blade 90° to the table (if applicable), mitre the blade to the right
as far as it will go, lock the saw arm in the down position, and lock
all knobs and levers.
Fig. 10
3
1
2
1 - Thread adjustment knob onto bolt
2 - Work stop adjustment knob
3 - Work stop
4 - Work support
5 - Bolt (M6 x 60mm)
Fig. 11
1
5
4
1 - Work support
2 - Bracket
3 - Height adjustment knob
4 - Work stop
5 - Support arm
8
4
5
2
3