Figure 2-7 Gigabit Ethernet Module Connectors And Leds; Table 2-4 Gigabit Ethernet Module Led Descriptions - Cisco 11500 Series Hardware Installation Manual

Chapter 2 Cabling the CSS
The GEM front panel LEDs indicate the network status for each of the connectors
(Link LEDs).
Figure 2-7
1
2
3
Table 2-4
Table 2-4
LED Name
Status (left)
Status (right)
78-13884-03
Figure 2-7
Gigabit Ethernet Module Connectors and LEDs
3
2
4
ST AT US
1
GE 1 LI NK
GE 2
Bicolor status LED (green and
red)
Amber status LED
LC-type SFP GBIC (one of two)
describes the GEM LEDs.
Gigabit Ethernet Module LED Descriptions
Color
Green
Red
No color Off
Amber
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Cabling the CSS 11503 and CSS 11506 Modules
illustrates the LEDs and connectors on a GEM.
4
5
LI NK
6
4
Link LED (next to its
corresponding SFP GBIC)
5
Spring-loaded screw (one of two)
6 Ejector (one of two)
State Indicates
Solid The module is ready.
Solid The module failed the power-up self
test during the boot process.
Slow blink The module failed.
The module failed and has no power.
Fast blink The module is running power-up self
test.
Slow blink The module is offline and active.
Solid The module is online and not active.
2-17