Cisco 1503 Software Manual page 9

Configuring IP and SNMP Parameters
The illustration below shows the network that is being configured in this section:
Figure 3-2
Server
Note
for your network. You should substitute them with the IP addresses that apply to your
network devices.
Step 1
Step 2
Example Network
PC PC
Micro Hub 1503
The network addresses used in the steps below are examples only; they will not work
Use the ip address command to configure the hub's IP address, subnet mask,
and gateway address:
Hub# ip address 172.16.10.2 255.255.255.0 172.16.10.1
Use the snmp community command to configure the SNMP communities and
their options:
Hub# snmp community 1 private rw
Configuring IP and SNMP Parameters
PC
E0
Router A
E1
SNMP network
management station
Using Your Hub Software 3-9