Cisco 1503 Software Manual page 34

Command Summary
Configuring Trap Managers
Use the commands in this section to configure the Micro Hub 1503 trap information. Trap
information enables the hub to send information to connected network devices. These
messages notify network devices about events on the network.
show ip trap-managers
Syntax:
Mode:
Description:
3-34
Cisco Micro Hub User Guide
show ip trap-managers
Guest
Displays information about authorized trap managers as shown in the following
example:
Hub> show ip trap-managers
Index IP Address
-----------------------------------------------
1 222.222.222.222
2 11.11.11.11
3 0.0.0.0
4 0.0.0.0
5 0.0.0.0
Command Display Definitions
• IP Address—IP address of the network management station.
• Community Name—Name used to identify an SNMP community.
• Status—Whether or not the community is enabled or disabled.
Community Name Status
public enabled
public disabled
public disabled
public disabled
public disabled