Table of Contents
Advertisement
Port Configuration Commands
Use the commands in this section to display or edit information about any port in the stack.
show port information
Syntax:
Mode:
Description:
show port information [hub id]
Guest
Displays information about all the network ports on the selected hub.
Command Keyword Definition
• hub id—(Optional) Number used to identify the hub in a stack. An integer
between 1 and 5. Read the section "Hub ID Numbers" earlier in this chapter
for information about how to determine hub ID numbers.
Information is displayed as follows:
Hub> show port information 1
Hub id: 1
Port ID Admin Status
------------------------------------------------------
1
enabled
2
enabled
3
enabled
4
enabled
5
enabled
6
enabled
7
enabled
8
enabled
Command Display Definitions
• Hub ID—Number used to identify the hub in a stack. An integer between 1
and 5. Read the section "Hub ID Numbers" earlier in this chapter for
information about how to determine hub ID numbers.
• Port ID—Number (1 through 8) of one of the yellow network station ports.
• Admin status—Whether or not the port has been manually disabled.
• Oper status—Whether or not the device connected to this port has a valid
connection to the hub.
• Partition status—Whether or not the port has been partitioned by the hub,
which usually happens as a result of a network loop.
Port Configuration Commands
Link Status
Partition Status
Not connected
not partitioned
Not connected
not partitioned
Connected
not partitioned
Not connected
not partitioned
Not connected
not partitioned
Connected
not partitioned
Not connected
not partitioned
Not connected
not partitioned
Using Your Hub Software 3-37
Advertisement
Table of Contents
