Cisco 1503 Software Manual page 31

SNMP Communities Commands
Use the commands in this section to configure the SNMP community strings. These strings
are used by the network management software to access the Micro Hub 1503.
show snmp communities
Syntax:
Mode:
Description:
show snmp communities
Administrator
Displays information about all of the configured community strings. Following
is example output from this command.
Hub> show snmp communities
Index Community Name
--------------------------------------------
1 public
2 private
3
4
Command Display Definitions
• Index—Index number of the community string.
• Community Name—Name used for management access. Can be up to 20
alphanumeric characters.
• Access Right—Management access setting: either read/write or read only.
• Status—Community string status: either enabled or disabled.
Management Configuration Commands
Access Right Status
read/write enabled
read only enabled
read only disabled
read only disabled
Using Your Hub Software 3-31