Cisco OL-4387-02 Configuration Manual page 99

Router service selection gateway configuration guide
Table of Contents

Advertisement

P
A fixed virtual circuit between two users. The public data network equivalent of a leased line. No call
permanent virtual
circuit
setup or clearing procedures are needed.
With point-to-point subinterfaces, each pair of routers has its own subnet. If you put the PVC on a
point-to-point
point-to-point subinterface, the router assumes that there is only one point-to-point PVC configured on
subinterface
the subinterface. Therefore, any IP packets with a destination IP address in the same subnet are
forwarded on this VC. This is the simplest way to configure the mapping and is, therefore, the
recommended method.
The abstraction used by Internet transport protocols to distinguish among multiple simultaneous
port
connections to a single destination host.
Point-to-Point Protocol. The successor to SLIP, PPP provides router-to-router and host-to-network
PPP
connections over both synchronous and asynchronous circuits.
PPP over ATM. Enables a high-capacity central site router with an Asynchronous Transfer Mode
PPPoA
(ATM) interface to terminate multiple remote PPP connections.
PPP over Ethernet. Allows a PPP session to be initiated on a simple bridging Ethernet connected client.
PPPoE
Refers to a signaling protocol defined within PPPoE as well as the encapsulation method. See also
RFC 2516.
PPP over Ethernet over ATM. Allows tunneling and termination of PPP sessions over Ethernet links
PPPoEoA
and allows for Ethernet PPP connections over ATM links.
PPP over Ethernet over on Ethernet. Allows tunneling and termination of PPP sessions over Ethernet
PPPoEoE
links and allows for Ethernet PPP connections over Ethernet links.
PPP over Ethernet over IEEE 802.1Q VLANs. Allows tunneling and termination of Ethernet PPP
PPPoEo802.1Q
sessions across VLAN links. IEEE 802.1Q encapsulation is used to interconnect a VLAN-capable
VLAN
router with another VLAN-capable networking device. The packets on the 802.1Q link contain a
standard Ethernet frame and the VLAN information associated with that frame.
PPP over PPPoA or PPPoE or both.
PPPoX
PPP terminated aggregation. A method of aggregating IP traffic by terminating PPP sessions and
PTA
aggregating the IP traffic into a single routing domain.
PTA-Multidomain. A method of aggregating IP traffic by terminating PPP sessions and aggregating the
PTA-MD
IP traffic into a VPN or multiple IP routing domains. For an ISP, the aggregated traffic either remains
in the ISP network or routes to the Internet. For a wholesale provider, the aggregated IP traffic is
forwarded to different destinations or domains depending on the service selected; thus the term
PTA-Multidomain.
Permanent virtual circuit or connection. Virtual circuit that is permanently established. PVCs save
PVC
bandwidth associated with circuit establishment and tear down in situations where certain virtual
circuits must exist all the time. In ATM terminology, called a permanent virtual connection. Compare
with SVC. See also virtual circuit (VC).
OL-4387-02
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
Glossary
GL-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

10000 series

Table of Contents