Configuration Of Multicast Protocols On Ssg Interfaces - Cisco OL-4387-02 Configuration Manual

Multicast Protocols on SSG Interfaces

Configuration of Multicast Protocols on SSG Interfaces

For SSG to forward multicast packets to the Cisco IOS routing engine, configure the following:
•
•
Note
•
For more information about multicast protocols on SSG interfaces, refer to
in the
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
9-4
Configure the interface where multicast packets are received as an uplink or downlink interface, or
bind a service to the interface.
Enable SSG multicast by using the ssg multicast command in global configuration mode. When
multicast is enabled, the SSG forwards to the Cisco IOS routing engine any multicast packets
received on an uplink or downlink interface with a service bound to it.
If you do not enable multicast, multicast packets received on the interface are dropped.
Enable IP multicast routing by using the ip multicast-routing command in global configuration
mode. For more information about the IP Multicast feature, refer to the
Broadband Aggregation, Leased-Line, and MPLS Configuration
Cisco 6400 Feature Guide, Release 12.2(2)B.
Chapter 9 Interface Configuration
Cisco 10000 Series Router
Guide.
"Service Selection Gateway"
OL-4387-02