Chapter 3 Ssg Logon And Logoff; Service Selection Gateway; Single Host Logon; Prerequisites For Single Host Logon - Cisco OL-4387-02 Configuration Manual

SSG Logon and Logoff
The Cisco 10000 series router supports the following SSG features for logon and logoff related
functions:
•
•
•
•
This chapter describes each of SSG logon and logoff features.

Single Host Logon

The Single Host Logon feature enables users to enter authentication information only twice. To log on
to a service through the SESM web application, a subscriber enters authentication information once for
the PPP session and once for the service. The subscriber does not have to log on to the SESM. Instead,
the SESM uses the PPP authenticated information from the SSG.
For non-PPP users, when a subscriber authenticates using the SESM application, the subscriber does not
have to log on again for the remainder of the non-PPP session. However, the subscriber still has to log
on to services. For more information, refer to
Policy Engine Installation and Configuration

Prerequisites for Single Host Logon

To use the Single Host Logon feature, you must install and configure Cisco SESM Release 3.1(1) or later.
OL-4387-02
Single Host Logon, page 3-1
SSG Autologoff, page 3-2
SSG Prepaid Idle Timeout, page 3-3
SSG Session and Idle Timeout, page 3-6
Cisco Subscriber Edge Services Manager and Subscriber
Guide.
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
C H A P T E R
3
3-1