Vpi/Vci Static Binding To A Service Profile; Restrictions For Vpi/Vci Static Binding To A Service Profile; Configuration Of Vpi/Vci Static Binding To A Service Profile - Cisco OL-4387-02 Configuration Manual

Miscellaneous SSG Features
This chapter describes the following SSG features:
•
•
•
•
•
•

VPI/VCI Static Binding to a Service Profile

The VPI/VCI Static Binding to a Service Profile feature allows users accessing SSG through a VPI/VCI
or a range of VPI/VCIs to access the server. When a user session arrives on a VPI/VCI or a VPI/VCI
range and the session specifies the username but does not specify the domain name, SSG maps the user
session to the service to which the VPI/VCI or VPI/VCI range is bound.
For more information, refer to
Node Route Processor—Service Selection Gateway Enhancements, Release 12.0(5)DC feature

Restrictions for VPI/VCI Static Binding to a Service Profile

The VPI/VCI Static Binding to a Service Profile feature has the following restrictions:
•
•
•

Configuration of VPI/VCI Static Binding to a Service Profile

To map a VC to a service, use the ssg vc-service-map command in global configuration mode. For more
information, refer to the
Cisco IOS Wide-Area Networking Command Reference, Release
OL-4387-02
VPI/VCI Static Binding to a Service Profile, page 11-1
RADIUS Virtual Circuit Logging, page 11-2
AAA Server Group Support for Proxy Services, page 11-2
Packet Filtering, page 11-3
SSG Unconfig, page 11-5
SSG Enhancements for Overlapping Services, page 11-7
The feature applies only to PPP sessions.
You must statically configure the feature.
SESM cannot map the VC to the service.
"Broadband Access: Service Selection Gateway Commands"
the"Configuring VPI/VCI Indexing to Service Profile"
Cisco 10000 Series Router Service Selection Gateway Configuration Guide
C H A P T E R
section in the
section in the
12.2T.
11
module.
11-1