Configuring The Router; Initial Configuration Using Sdm; Initial Configuration Using The Setup Command Facility - Cisco 3700 Series Hardware Installation Manual

Chapter 3 Installing the Router
If the
Note
ROM monitor, see the router rebooting and ROM monitor information in the
Fundamentals Configuration Guide

Configuring the Router

You can configure your router by using one of the following tools:
•
•
•
If you need help with interface and port numbering, see the
Note

Initial Configuration Using SDM

If Security Device Manager has been installed on your router, the following messages appear at the end
of the startup sequence:
yourname con0 is now available
Press RETURN to get started.
For configuration procedures using SDM, see the quick start guide that shipped with your router.
You can also access the
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3700/37xx_qsg/index.htm

Initial Configuration Using the Setup Command Facility

This section shows how to use the setup command facility to configure a host name for the router, set
passwords, and configure an interface for communication with the management network. If you see the
following messages at the end of the startup sequence, the setup command facility has been invoked
automatically:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
OL-2180-08
prompt appears, your system has booted in ROM monitor mode. For information on the
rommon 1>
Security Device Manager. If your router was purchased with a VPN bundle, Security Device
Manager is installed on the router. See the
Setup command facility. You can use the setup command facility to prompt you for basic router
information. After the configuration file has been created, you can use the CLI or use Security
Device Manager to perform additional configuration. See the
Command Facility" section on page
Command-line interface (CLI). If you prefer to use the Cisco IOS CLI, see the
Using the CLI (Manual Configuration)" section on page 3-32
Cisco 3700 series routers quick start guides
for your Cisco IOS software release.
"Initial Configuration Using SDM" section on page
3-29.
"Interface Numbering" section on page
Cisco 3700 Series Routers Hardware Installation Guide
Configuring the Router
Cisco IOS Configuration
"Initial Configuration Using the Setup
"Initial Configuration
for instructions on how to use the CLI.
online at:
3-29.
1-5.
3-29