Cisco 3700 Series Hardware Installation Manual page 74

Powering Up the Router
The following indications appear:
Cisco 3725 router
•
–
–
Cisco 3745 router
•
–
–
Depending on your installation, Fast Ethernet (0/0, 0/1) and Network Module (Active, Ready) LEDs
might also come on.
If you encounter problems when you power up the router, see
Messages begin to appear in your terminal emulation program window.
Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
interpreted as the first command typed when the messages stop, which might cause the router to power
down and start over. It takes a few minutes for the messages to stop.
You may see different startup messages:
If you see the following messages, the router has booted with a configuration file and is ready for
•
initial configuration using Security Device Manager (SDM).
yourname con0 is now available
Press RETURN to get started.
If SDM is installed on your router, we recommend using SDM to perform the initial configuration.
For configuration procedures using SDM, see the quick start guide that shipped with your router.
You can also access the
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3700/37xx_qsg/index.htm
If you see the following messages, the router has booted and is ready for initial configuration using
•
the setup command facility or the command line interface (CLI).
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
To learn how to use the setup command facility to configure the router, see the
Using the Setup Command Facility" section on page
the router, see the
page
Cisco 3700 Series Routers Hardware Installation Guide
3-28
The green power LED on the front of the chassis comes on.
The fan operates.
The green SYS PS1 LED on the front of the chassis comes on if power supply 1 is in use; the
green SYS PS2 LED comes on if power supply 2 is in use.
The fan operates.
Cisco 3700 series routers quick start guides
"Initial Configuration Using the CLI (Manual Configuration)" section on
3-32.
Chapter 3
Appendix A, "Troubleshooting."
online at:
"Initial Configuration
3-29. To learn how to use the CLI to configure
Installing the Router
OL-2180-08