Advertisement
Removing a CFC or DFC Daughter Card
Note
Step 6
With your left hand, lift slightly at the location shown in
card up and down to unseat the daughter card from the module connectors.
Figure 8
Step 7
Holding the DFC3 daughter card with both hands, carefully lift the back end of the DFC3 daughter card
up slightly to clear the module connectors, and then carefully slide the DFC3 daughter card out from
under the two front stiffener bracket tabs. Lift the DFC3 daughter card straight up from the module (see
Figure
pad, or in an antistatic bag.
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
18
The two screws securing the DFC3 daughter card that pass through the front stiffener bracket
tabs are longer than the remaining DFC installation screws.
Unseating the DFC Connectors (WS-X6748-GE-TX Equipped with a Front Stiffener
Bracket)
WS-X5530
9) and immediately place the removed DFC3 daughter card on an antistatic mat, antistatic foam
Figure
Lift here
8, and gently rock the DFC3 daughter
Lift
here
78-15893-08
Advertisement
