Advertisement
Removing a CFC or DFC Daughter Card
Removing the DFC3 Daughter Card from Modules without Stiffener Brackets
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
To remove the DFC3 daughter card from modules that are not equipped with a stiffener bracket, follow
these steps:
Step 1
Attach an ESD grounding strap to your wrist and to ground.
If you are unsure about the correct way to attach an ESD grounding strap, refer to the
ESD Grounding Strap" section on page 42
Step 2
Remove the Ethernet module from the chassis.
If you are unsure about the correct procedure for removing a module from the switch chassis, refer to
the
Step 3
Place the Ethernet module on an antistatic mat with the front of the module facing toward you.
If your DFC daughter card has a small metal installation bracket as shown in
Step 4
Phillips-head screwdriver to remove the two cap nuts and the one screw securing the bracket. Set them
aside with the bracket. If there is no bracket, just remove the two cap nuts and the one screw.
Remove the remaining installation hardware. (See
Step 5
Note
The installation hardware shown in
installation hardware for a DFC3C or a DFC3CXL daughter card consists of 6 screws, 2 cap nuts, and 1
standoff.
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
12
"Removing an Ethernet Module from the Chassis" section on page 34
for instructions.
Figure
3.)
Figure 3
is for a DFC3B or DFC3BXL daughter card. The
"Attaching Your
for removal instructions.
Figure
3, use a No.1
78-15893-08
Advertisement
