Advertisement
Figure 3
Partially reinstall the cap nut, rotating about 3 turns so that there is a space of about 1/8 inch (3 mm)
Step 6
between the bottom of the cap nut and the top of the DFC3 daughter card, as shown in
nut acts as a stop when you unseat the daughter card connector so that the DFC3 daughter card does not
move horizontally and cause damage to the base board.
78-15893-08
Removing the DFC Daughter Card Installation Hardware
WS-X5530
Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note
Removing a CFC or DFC Daughter Card
Installation
bracket. May
or may not
be present.
Figure
4. The cap
13
Advertisement
