Cisco AS5400 Quick Start Manual page 51

SPE Firmware
SPE firmware is automatically downloaded to a universal port DFC from the Cisco AS5350 or Cisco AS5400 when you boot
the system for the first time or when you insert a universal port DFC while the system is operating. When you insert DFCs while
the system is operating, the Cisco IOS image recognizes the cards and downloads the required firmware to the cards.
The SPE firmware image is bundled with the universal gateway Cisco IOS image. The SPE firmware image uses an auto detect
mechanism, which enables the universal port DFC to service multiple call types. An SPE detects the call type and automatically
configures itself for that operation. The firmware is upgradable independent of Cisco IOS upgrades, and different firmware
versions can be configured to run on SPEs in the same DFC.
The universal port DFC supports the modem standards and features listed in the following table.
Modem Standards and Supported Features
Feature
Carrier protocols
Error-correcting link-access protocols V.42 LAPM, MNP 2-4
Compression protocols
Command interface
In-band signaling/tone generation
and detection
Other
The modem speed 115200 bps and hardware flow control are the default settings for integrated modems.
Note
To configure the lines and ports to allow users to dial in to your network, follow these steps:
Step 1 Use the enable command and password to enter privileged EXEC mode. You are in privileged EXEC mode when the
prompt changes to
Gateway> enable
Password: password
Gateway#
Description
ITU V.23 at 75/1200 bps
Telcordia Technologies (formerly Bellcore) 103 at 300 bps
ITU V.21 at 300 bps
ITU V.22 at 1200 bps
Telcordia Technologies (formerly Bellcore) 212A at 1200 bps
ITU V.22bis at 2400 bps
ITU V.32 up to 9600 bps
ITU V.32bis up to 14,400 bps
V.32 turbo up to 19,200 bps
V.FC up to 28,800 bps
V.34 up to 28,800 bps
V.34+ up to 33.6 bps
TIA/ITU V.90
K56flex
V.42bis (includes MNP 5)
Superset of the AT command set
DTMF generation
DTMF detection
MF generation
MF detection
Out-of-band access for management
PPP and SLIP framing
.
Gateway#
51