Cisco AS5400 Quick Start Manual page 20

Connecting 8-Port DFC on Cisco AS5400 to RJ-45 Jack
T1/E1 8 PRI
connector
RJ-45-to-RJ-45 cable
For other T1 cabling options, see the card installation guide for the Cisco AS5350 and Cisco AS5400. You can access
Note
this document at Cisco Product Documentation > Access Servers and Access Routers > Access Servers > Cisco AS5350
or Cisco AS5400 > Hardware Installation Documents for Cisco AS5350 or Cisco AS5400.
• Connect each E1/PRI port to an RJ-45 jack with a straight-through RJ-45 to RJ-45 cable.
If you choose a port with 75-ohm input impedance, use an RJ-45-to-75-ohm coaxial cable adapter and plug it into
Note
that port. Use software commands to choose a particular port and the line termination on that port. For
information on software commands, see the
Configuration Guide .
Warning The E1 interface card may only be installed in an ACA-permitted customer equipment or a Data Terminal Equipment
(DTE) that is exempted from ACA's permit requirements. The customer equipment must only be housed in a cabinet
that has screw-down lids to stop user access to overvoltages on the customer equipment. The customer equipment
has circuitry that may have telecommunications network voltages on them. To see translations of the warnings
that appear in the publication, refer to the Regulatory Compliance and Safety Information document that
accompanied this device.
20
Straight-through
RJ-45 jack
Cisco AS5350 and Cisco AS5400 Universal Gateway Software