Cisco AS5400 Quick Start Manual page 35
Cisco systems universal gateway quick start guide
Hide thumbs
Also See for Cisco AS5400:
- Installation manual (88 pages) ,
- Configuration manual (262 pages) ,
- Regulatory compliance and safety information manual (68 pages)
Table of Contents
Advertisement
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] : 255.255.255.128
Class B network is 172.22.0.0, 25 subnet bits; mask is /25
Do you want to configure FastEthernet0/0
Step 14 Configure your serial interfaces by responding to the following prompts:
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
IP address for this interface interface: 172.22.50.11
Subnet mask for this interface: 255.255.0.0
Do you want to configure Serial0/1 interface? [yes]: no
Configuring interface Group-Async1:
Step 15 After you complete the configuration script, the setup script displays the configuration command script. Review your
new configuration and then make the appropriate selection below:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Initial Configuration Using CLI (Manual Configuration)
This section shows how to perform basic configuration using the command line interface (CLI).
Step 1
To proceed with manual configuration using CLI, enter no.
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
To terminate autoinstall and continue with manual configuration, press Return:
Would you like to terminate autoinstall? [yes] Return
Step 3
To bring up the
Router>
...
Router>
Enter privileged EXEC mode.
Step 4
Router> enable
Router#
Step 5
Enter global configuration mode. You are in global configuration mode when the prompt changes to
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 6
Changes the name of the gateway to a meaningful name:
Router(config)# hostname Gateway
Gateway(config)#
interface? [yes]: no
interface? [no]: yes
prompt, press Return:
Router(config)#.
35
Advertisement
Table of Contents
