Connect A Console Terminal - Cisco AS5400 Quick Start Manual

System Management and Power Connections
The connections described here provide electrical power and management access. For cable pinouts, see the chassis and card
installation guides for the Cisco AS5350 and Cisco AS5400. You can access these documents at Cisco Product Documentation
> Access Servers and Access Routers > Access Servers > Cisco AS5350 or Cisco AS5400 > Hardware Installation Documents for
Cisco AS5350 or Cisco AS5400.
Power and Management Cable Connections
Port or Connection
Console
Auxiliary
Power (AC)
Power (DC)
Bantam jack
Alarm
BITS port
WAN, LAN, and Voice Connections
The following table summarizes the WAN, LAN, and voice connections.
WAN, LAN and Voice Connections
Port or Connection Port type, color
Ethernet RJ-45, Yellow
T1/E1 WAN RJ-45
36-pin serial
T3 WAN BNC

Connect a Console Terminal

Use the console terminal for local administrative access to the universal gateway. You can only connect a terminal to the console
port. You can use the auxiliary port to connect a terminal or a modem for remote access to the universal gateway.
To connect a terminal (an ASCII terminal or a PC running terminal emulation software) to the console port on the Cisco AS5350
or Cisco AS5400, follow this procedure.
Color or
Type Connected to:
Light blue PC or ASCII terminal communication
port (usually labeled COM)
Black Modem for remote access
Power 100-240 VAC, 50-60 Hz
cable
Refer to the "Connect DC Power" section on page 27 for instructions about the DC power
connections.
Test device
Alarm device
Signal generator
Connected to:
Ethernet hub
T1 or E1 network
T3 network
Cable
RJ-45-to-RJ-45 rollover cable (included)
and terminal adapter (included).
RJ-45-to-RJ-45 rollover cable and a
modem adapter (included).
Grounding power cord (included).
12 or 14 AWG copper wire
Coax cable
Cable
Straight-through Ethernet
RJ-45 to DB-15
RJ-45 to BNC interface cable for
unbalanced connections
RJ-45 to Twinax interface cable for
balanced connections
RJ-45 to RJ-45
RJ-45 to bare wire
8-port interface cable
BNC to BNC
15