Connecting The Scanner To The Computer; Interface Connector Locations - Canon imageFORMULA DR-X10C User Manual

4.

Connecting the Scanner to the Computer

There are two methods for connecting the DR-X10C scanner to a computer: a USB connection to a standard USB port built in to
the computer, or SCSI connection to a SCSI card installed in an expansion slot of the computer. Select the method that is best suited
to your computer environment.

Interface Connector Locations

The USB port and SCSI connector are located on the scanner
as shown below.
a
USB Connector
b
SCSI Connector
(D-sub, 50-pin half-pitch)
c
DIP Switches for SCSI ID
IMPORTANT
• Do not connect both USB and SCSI cables to the scanner at the
same time.
• Use only the supplied power cord.
• The scanner and computer should both be turned OFF when
making connections.
• Make sure that the computer is turned OFF before connecting the
SCSI cable. The scanner may not be properly recognized by the
computer if it is connected while the computer is turned ON.
• A SCSI cable is not supplied with the scanner. Obtain a cable with
connectors that match the SCSI connectors on both the scanner
and the computer.
Power Connector
2-6

Connecting the Scanner to the Computer

To connect to the computer, follow the procedure for the
intended connection method.
■ Using a USB Connection
1.
Connect the supplied power cord into the power
connector on the back of the scanner. a
Connect the power cord into an AC outlet. b
2.
120 V Type
220 - 240 V Type
Chapter 2 Setup