Table of Contents
Advertisement
Plastic blade
NOTICE:
Be sure to use genuine Makita plastic
blade.
While holding down the spindle lock button, place the
plastic blade onto the spindle and tighten it securely by
hand.
4
5
2
3
Fig.13
► 1 . Plastic blade 2. Spindle 3. Spindle lock button
4. Loosen 5. Tighten
To remove the plastic blade, loosen the plastic blade
while holding down the spindle lock button.
NOTE: You can also use the supplied hex wrench to
install/remove the cutting tool. Insert the hex wrench
to the hole as shown in the figure to lock the spindle.
Fig.14
► 1 . Hex wrench 2. Hole
CAUTION:
Always use the supplied wrenches
to install/remove the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the
cutting tool.
Hex wrench storage
CAUTION:
wrench inserted in the tool head. It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
Fig.15
► 1 . Loop handle 2. Hex wrench
FUNCTIONAL DESCRIPTION
WARNING:
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Failure to switch off and remove the battery cartridge may
result in serious personal injury from accidental start-up.
Installing or removing battery cartridge
2
CAUTION:
installing or removing of the battery cartridge.
CAUTION:
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
1
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
Fig.16
► 1 . Red indicator 2. Button 3. Battery cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
13 ENGLISH
Be careful not to leave the hex
Always be sure that the tool is
Always switch off the tool before
Hold the tool and the battery car-
2
1
1
2
3
Advertisement
Table of Contents
