Buffalo Benelli Classica Series Instruction Manual page 9

2.) Charge The Battery
Once the bike is out of the box, put the kickstand down. Charging of the battery pack can be
done on or off the bike. To remove the battery first insert the key into the keyhole near the
battery and turn to unlock. The battery should then slightly pop out allowing you to pull the
battery off the bike.
NOTE: Connect the charger to the bicycle when it is not used. This will lengthen the life of the
battery pack.
A. Connect the charger to the main voltage. The charge indicator of charger will show green.
B. Connect the plug of the charger to the contact point of battery pack, the charge indicator of
charger will show red.
C. Once the battery pack has been completely charged it will change from red to green.
D. Remove the charger before you start cycling.
E. Attach the battery pack by aligning the battery pack to the card. Push hard and battery will
"click" if installed properly.
NOTE: Always charge indoors and allow battery to reach room temperature before charging.
Make sure charger and A/C outlet are the same voltage. Make sure the area is free from
combustibles to avoid fire from overheating.
DO NOT COVER THE CHARGER. DO NOT LEAVE FULLY
CHARGED BATTERY CONNECTED TO THE CHARGER. UNPLUG THE CHARGER FROM
THE WALL OUTLET WHEN NOT IN USE.
3.) Fitting The Pedals
Before attaching pedals apply lubricant grease to the threaded end of each pedal. The pedals
are marked "L" for left pedal and "R" for right pedal. You must make sure you have the correct
pedal before attempting to attach to the pedal arm crank.
9