Buffalo Benelli Classica Series Instruction Manual page 10

The marking can be found at the end of the axel pedal that will be inserted into the pedal arm
crank.
Left Pedal must be tightened counter clockwise into left arm crank. Carefully tighten using the
supplied pedal wrench until the pedal is fully tightened.
Right Peal must be tightened clockwise into right arm crank (located on the same
•
side as bike chain).
Both pedals (each side L and R) thread toward the front of the bike to tighten, and
•
toward the back of the bike to loosen.
seriously damage pedal and/or pedal crank arm.
4.) Adjust The Handlebars
Holding the tire in place, adjust the angle the handlebars by loosening the nut(s) on top of the
handlebar stem with provided hex key. Then align the handlebars with the frame and front tire.
Tighten two nuts on both sides of the handlebar.
The angle of the handlebar can be raised or lowered depending on your preference. To
change handlebar height, loosen the nut(s) on the side or front of the handlebar joint and
adjust the handlebars to a comfortable position before tightening. Check to make sure the
brake levers, gear shifts, displayer, bar ends and other parts attached to the handlebars are
positioned comfortably. These can all be adjusted using one of the included hex keys.
Screwing the right pedal into the left crank arm and/or vice versa will
10