Buffalo Benelli Classica Series Instruction Manual page 26

Readjusting The Rear Brakes
After checking that the wheel does not
easily run while the brake cable is
being pulled, depress the brake lever
about 10 times as far as the grip in
order to run the brake cable
(A) Depress about 10 times
NOTE: If brake cable is not run in, it
will need to be adjusted again after
only a short period of use.
Turn the cable adjustment bold (A) of
the brake unit or brake lever so that
there is a 15mm gap.
(The amount of brake lever gap is the
distance from the position where the
brake lever is not operated to the
position where a force is felt suddenly
when the brake lever is pulled.)
(A) Cable Adjustment bolt
After depressing the brake lever to check
the braking performance, secure the
cable adjustment bold with the cable
adjustment nut (B).
26