Battery Information System - Buffalo Benelli Classica Series Instruction Manual

Observe the following points to increase the service life of your eBike Samsung Battery:
Make sure that the battery is fully charged before you ride your bike for the first time or after
you have not used it for a while.
You should run the battery all the way down to empty for the first three charging cycles. This
allows the battery to reach its maximum capacity.
If you continuously run the battery to empty during normal operation, this reduces its service
life.
If you partially recharge the battery frequently during normal operation, this has a favorable
effect on its service life.
You should therefore partially recharge the battery whenever possible: Try not to run the
battery all the way down to empty and recharge it even after a short period of operation.
If you are having problems with the battery, place it in the charger for one minute. A reset
occurs, during which the battery management disables sleep mode for example. After this, the
battery will work again.
Ideally you should charge the battery at a temperature of between +10 °C and +30 °C. It takes
longer to charge the battery at low temperatures, the battery will not charge up at
temperatures higher than
+30 °C. Ideally, you should charge and store the battery inside your house or in a warm
garage when the outside temperature is low. In this case you should only fit the battery on
your bike just before using it.
If you are transporting your eBike by car, take the battery out of its holder and transport it
separately.
The battery is ideally stored for longer periods charged to 75% of its capacity at a temperature
of +10 °C

Battery Information System

There is a control panel with four LEDs and a button ("Push") on the side of the battery that
faces outwards. The 4 LEDs indicate the charge level. To see what level the battery is
35