Table of Contents
Advertisement
TURN ON/OFF
In order to power the LCD Display you must first hold the magnetic Benelli by Buffalo Corp key
(that is provided) over the middle of the LCD Display. The electric system will magically turn
on showing all the display features as seen in above "Picture 1".
NOTE: You must first make sure the Samsung Battery pack is properly attached and
charged before LCD Display will work. Once battery is attached the switch will need to be in
the start position where the GREEN light is illuminated.
Put the key in a safe place until the LCD Display needs to be turned ON again.
BATTERY POWER INDICATOR
The battery power level is shown on ① Battery Power Indicator. The image shown in "Picture
1" shows the indicator with full power. When the battery is fully charged there will be four black
segments shown. When riding the eBike in assist mode it will consume power slowly and one
by one the segments will be eliminated. When the battery is low the last battery segment will
begin to flash. The battery must be recharged immediately to continue Power Assist Mode.
POWER ASSISTED LEVEL ADJUSTMENT
The level of assistance of the Benelli by Buffalo Corp eBike can be adjusted when pedaling
via the ⑥ Power Shifting Handle.
To increase the assistance level, twist power shifting handle forward.
Level 0 is "OFF": The drive is switched off; the eBike can be operated as a normal bicycle
through pedaling with no power assistance.
Level 1 is "ECO": Effective assistance at maximum efficiency for maximum cruising range.
Level 2 is "Tour": Uniform assistance, for touring with long cruising range.
Level 3 is "Sport": Powerful assistance for sporting riding off road as well as for urban traffic.
Level 4 is "Turbo": Maximum assistance supporting highest cadence for sporting riding.
To decrease the level of assistance twist power shifting handle backward to your desired
power level as noted above.
22
Advertisement
Table of Contents
