SKE-Series Voice Evacuation System Installation/Operation Manual
7.3.2
Wiring Instructions
The wiring for the remote microphone should use shielded 4 conductor 22AWG (up to 5000
feet) wiring. The wiring is supervised by the main panel if switch 4 on SW2 is set to ON (see
Table 4-1).
Figure 7-4 illustrates how to wire the SKE-SRM to the main control panel. See also Table 7-1.
Microphone gain
Figure 7-4 The SKE-SRM Wiring Connections to the SKE-450
Remote Mic
Terminals
+
–
Active
Out
7-4
Table 7-1: Wire Terminations
Main Control Terminals
Remote Microphone
+
–
Connect to
Connect to
firealarmresources.com
Supervised
Power Limited
Active
In
Connect to
Connect to
151267