Table of Contents
Advertisement
SKE-SeriesVoice Evacuation System Installation/Operation Manual
4.2.1
Input Message 3 From the Microphone
This section contains information on how to record and erase message 3 from the control
panel.
4.2.1.1 Record Message 3 Using the Microphone
Follow these steps to record message 3 using the microphone:
1. Place DIP switch number 8 of SW2 to the "On" position.
The trouble relay will energize.
Important! When the SKE-450 is in Record Mode, the trouble relay will energize and CMD1 relay
will be open. Alarms will not be detected while the system is in Record Mode.
2. Press in the microphone switch and speak the desired message (49 seconds maximum).
While your message is being recorded, the Speaker Trouble LED will flash. Once the
microphone switch is released, the Mic Trouble LED will Light.
If there is an error in the flash memory while recording, the Mic Trouble LED will flash.
Then erase the message, and record message again.
Note: Once a message is recorded, a new message can not be recorded over it until the previous message is
erased.
3. When you have completed recording message 3, return DIP switch number 8 of SW2 to
the "Off" position.
4.2.1.2 To Erase Message 3
Follow these steps to erase message 3:
1. Place DIP switch number 8 of SW2 to the "On" position.
The trouble relay will energize.
2. Press and hold Message Test Button S2 until the Speaker Trouble LED lights.
3. If you wish to record a new message, follow the steps listed in Section 4.2.1.1.
OR
4. Return DIP switch number 8 of SW2 to the "Off" position.
4.2.2
Input Message 3 From a PC
There are two ways to input message 3 into the system using a PC or laptop computer.
Message 3 can be recorded from the audio output of a PC sound card, or through the serial
port using the 7780 software.
4-4
firealarmresources.com
151267
Advertisement
Table of Contents
