Cobra Fi2000 Instruction Manual

Items Supplied >
1 – Fi2000AT Fuel Injection Module
2 – Zip Ties
Instruction Manual >
Read all instructions carefully and completely before installing your new Fi2000AT module.
It is recommended that a qualified mechanic or technician install this product.
1. Remove the gas tank cover by unscrewing the one dzus fastener under the seat, at the back of the
cover, then lift the cover clear.
Lay the Fi2000 module in place, but do not attach it to the motorcycle, and run the wiring harness over
2.
the radiator cap neck and drop the wires down inside the right frame rail (see figure 1).
Locate the factory connector on each fuel injector (see figure 2 and 3). Depress the wire clip on the rear
3.
injector and pull the connector free and move out of way. Now remove the front connector out of the
way. The wires are clearly marked as to front and rear cylinder. Note: A pair of needle nose pliers and
a long flat blade screwdriver helps with this job.
Attach the Fi2000 module's forward injector plug, with the gray and red wires, onto the front injector.
4.
Then take the original HD front connector and insert the corresponding Fi2000 connector, with the
brown and red wires, into it. Any extra wire and connection you just made place down and under the
rear injector. (see figure 2)
Attach the Fi2000 module's rear injector plug, with the blue and red wires, onto the rear injector. Then
5.
take the original HD rear connector and insert the corresponding Fi2000 connector, with the green and
red wires, into it. (see figure 3)
Route the wires from the Fi2000 next to the black coolant pipe using the zip ties so that the wires stays
6.
clear of the throttle linkage.
Raise the fuse box and attach the black wire to the bolt shown in figure 4. Reinstall fuse box.
7.
8. Verify the wire connections; turn on the ignition and watch the Fi2000 LED logo, confirm that the LED
blinks several times then turns off. If you do not see any blinking, it may be necessary to wait for the
alarm to reset (if applicable) and try again. Also confirm the side stand is up, bike is in neutral, clutch is
in and handle bar engine switch is set to run (where applicable). Start the bike and the Fi2000 logo
should remain solid red, which confirm the unit is fully functioning. If it flashes while the bike is running,
turn off the bike and recheck that all harness connections (injectors, ground wire, and O2 sensors when
applicable) have been properly made. Re-verify by turning ignition on while watching for flashing LED,
prior to starting. Start and confirm LED remains ON solid red. NOTE: Make sure ignition is turned off
before attempting to change any Fi2000 harness connections.
Remove the backing from the Velcro and attach the Fi2000 to the air box base as shown in fig 1.
9.
10. Reattach the gas tank cover and seat.
* Cobra® recommends you always wear a helmet while riding. Please never operate your motorcycle while under
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
DOCUMENT NO. 0017 REV. A
04/11
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
®
Application(s) >
HARLEY V-Rod 02-07
692-1601AT
www.fi2000r.com
Page 1 of 2