Reversing switch action
Fig.5: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
Speed change
Fig.6: 1. Speed change lever
CAUTION:
Always set the speed change lever
fully to the correct position. If you operate the
tool with the speed change lever positioned halfway
damaged.
CAUTION:
Do not use the speed change lever
while the tool is running.
Adjusting the fastening torque
Fig.8: 1.
ring 3. Graduation 4.
Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which
the screw size and graduation.
Graduation
Machine screw
Wood
Soft wood
screw
(e.g. pine)
Hard wood
(e.g. lauan)
2.
1
2
3
4
5
6
M4
–
–
Position of
speed
change lever
1
2
-
If the tool speed is coming down extremely during the
the operation.
Selecting the action mode
-
CAUTION:
your desired mode mark. If you operate the tool
with the ring positioned halfway between the
mode marks, the tool may be damaged.
CAUTION:
from "
" to other modes, it may be a little dif-
this case, switch on and run the tool for a second
at the "
" position, then stop the tool and slide
the ring to your desired position.
Fig.7: 1.
ring 3. Graduation 4.
•
Drilling mode (rotation only)
•
Hammer drilling mode (rotation with
hammering)
•
Screwdriving mode (rotation with clutch)
action mode changing ring and align the mark that you
7
8
9
10
11
M5
3.5 x 22
4.1x 38
3.5 x 22
8 ENGLISH
Speed
Torque
Low
High
High
Low
Always set the ring correctly to
When you change the position
12
13
14
15
16
17
M6
4.1x 38
Applicable
operation
Heavy load-
ing operation
Light loading
operation
2.
18
19
20
–
–