SPECIFICATIONS Model: HP332D Drilling capacities Concrete 8 mm Steel 10 mm Wood 28 mm Fastening capacities Wood screw 5.1 mm x 63 mm Machine screw No load speed High (2) 0 - 1,500 min Low (1) 0 - 450 min...
Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium 11.6.2015 ication. Use personal protective equipment. Always wear eye protection.
Only use genuine Makita batteries. have been altered, may result in the battery bursting could give the operator an electric shock. also void the Makita warranty for the Makita tool and sure no one is below when using the tool in charger.
Never recharge a fully charged battery car- Battery protection system tridge. Overcharging shortens the battery service life. Charge the battery cartridge with room tem- perature at 10 °C - 40 °C (50 °F - 104 °F). Let extend battery life. a hot battery cartridge cool down before charging it.
Switch action Reversing switch action 1. Switch trigger 1. Reversing switch lever CAUTION: CAUTION: Before inserting the battery car- Always check the direction of tridge into the tool, always check to see that the rotation before operation. switch trigger actuates properly and returns to CAUTION: Use the reversing switch only after the "OFF"...
Position of Speed Torque Applicable speed operation change lever High Heavy load- ing operation High Light loading operation correct position before operation. If the tool speed is coming down extremely during the the operation. 3. Graduation 4. Selecting the action mode CAUTION: Always set the ring correctly to Drilling mode (rotation only)
Installing driver bit holder ASSEMBLY Optional accessory CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ drill bit Optional accessory 1.
Page 9
First, turn the action mode changing ring so that the Drilling in metal arrow on the tool body points to the marking. hole, make an indentation with a center-punch and apply pressure to the tool. Start the tool slowly and then increase the speed gradually.
OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool accessories or attachments might present a risk of for its stated purpose. 1. Holster holder 2. Waist belt If you need any assistance for more details regard- ing these accessories, ask your local Makita Service ster button.
Page 12
M a k i t a J a n - B a p t i s t V inkstraat 2, 3070, Belgium Makita Corporation Anjo, Aichi, Japan w w w . m a k i t a . c o m...