Maintenance; Pump Strainer Basket; Cleaning The Pump Strainer Basket; Winterizing - Black & Decker BDXBTVAR150 Instruction Manual

Page 14 ENGLISH
DO NOT open the strainer pot if Variable Speed Pump fails to prime or if pump has been operating
WARNING
without water in the strainer pot. Pumps operated in these circumstances may experience a build-up of vapor
pressure and may contain scalding hot water. Opening the pump may cause serious personal injury. In order to
avoid the possibility of personal injury, make sure the suction and discharge valves are open and strainer pot
temperature is cool to touch, then open with extreme caution.
To prevent damage to the pump and for proper operation of the system, clean pump strainer and skimmer
CAUTION
baskets regularly.

5. Maintenance

5.1 Pump Strainer Basket

The pump strainer basket (or 'strainer pot', 'hair and lint pot'),
is located in front of the volute. Inside the chamber is the
basket which must be kept clean of leaves and debris at
all times. View basket through the 'See Through Lid' to
inspect for leaves and debris.
Regardless of the length of time between filter cleaning,
it is most important to visually inspect the basket at least
once a week.

5.2 Cleaning the Pump Strainer Basket

CAUTION:
Press the Start/Stop button to stop the
pump and turn off the pump at the circuit breaker. Relieve
pressure in the system by allowing the water to cool.
1. Gently tap the clamp in a counter-clockwise direction to
remove the clamp and lid.
2. Remove debris and rinse out the basket. Replace the
basket if it is cracked.
3. Put the basket back into the housing. Be sure to align the
notch in the bottom of the basket with the rib in the
bottom of the volute.
4. Fill the pump pot and volute up to the inlet port with water.
5. Clean the cover, O-ring, and sealing surface of the pump
pot. Note: It is important to keep the lid O-ring clean and
well-lubricated.
6. Reinstall the lid by placing the lid on the pot. Be sure the
lid O-ring is properly placed. Seat the clamp and lid on
the pump then turn clockwise until the handles are
horizontal.
7. Turn the power on at the house circuit breaker. Reset the
pool time clock to the correct time, if applicable.
8. Open the manual air relief valve on top of the filter.
9. Stand clear of the filter. Start the pump.
THIS SYSTEM OPERATES UNDER HIGH
WARNING
PRESSURE.
system (e.g., Lock Ring, Pump, Filter, Valves,
etc.) is serviced, air can enter the system and
become pressurized. Pressurized air can cause
the lid to separate which can result in serious
injury, death, or property damage. To avoid this
potential hazard, follow above instructions.
When any part of the circulating
Installation & Operation Manual
10. Bleed air from the filter until a steady stream of water
comes out. Close the manual air relief valve.

5.3 Winterizing

You are responsible for determining when freezing
conditions may occur. If freezing conditions are expected,
take the following steps to reduce the risk of freeze damage.
Freeze damage is not covered under warranty.
CAUTION:
To prevent freeze damage, follow the
procedures below. Press the Start/Stop button to stop
the pump and shut off electrical power for the pump at the
circuit breaker.
1. Drain the water out of the pump housing by removing
the two thumb-twist drain plugs from the housing. Store
the plugs in the pump basket.
2. Cover the motor to protect it from severe rain, snow,
and ice.
Note: Do not wrap motor with plastic or other air tight
materials during winter storage. The motor may be
covered during a storm, winter storage, etc., but never
when operating or expecting operation.
Note: In mild climate areas, when temporary freezing
conditions may occur, run your filtering equipment all
night to prevent freezing.
Strainer Pot Assembly
Strainer Cover Kit
O-Ring
Basket
Pump Housing