Indication Lamp - Makita XHU02 Instruction Manual

► 1. Switch trigger A 2. Switch trigger B 3. Lock-off
button

Indication lamp

► 1. Indication lamp
Running the tool allows the indication lamp to show the battery cartridge capacity status.
When the tool is also overloaded and has stopped during operation, the lamp lights up in red.
Refer to the following table for the status and action to be taken for the indication lamp.
Red Indicator Light
Light Blinks
Light Stays On
(See Note 1 below)
Note 1: When attempting to switch the tool on, the indicator light may continue to come on
due to the tool and/or the battery pack being too warm. The battery tool and battery
pack will need to be allowed to cool down before further use.
3
1
1
Condition
This indicates the battery
level is getting low.
The remaining battery capacity
is too low and the tool will not
operate.
The battery protection system
has been activated due to the
tool being overloaded.
For your safety, this tool is equipped with a dual switch-
ing system. To turn on the tool, press the lock-off button
2
and triggers A and B. Release either one of the two
pressed triggers to turn off. The sequence of switch-
ing is unimportant as the tool only starts when both
switches are activated.
Action to be taken
Recharge the battery cartridge.
Remove and recharge the
battery.
Release the switch trigger on
the tool and stop the application
that caused the tool to become
overloaded.
Then pull the switch trigger again
to restart.
7 ENGLISH